If you want to install the floor, the bamboo floor is a very good choice, the quality is very good, the service life is very long. So today, Xiaobian will introduce some installation methods of outdoor bamboo floor for you to help you better purchase use outdoor bamboo floor, so that we can have a better use effect bring good home decoration effect.

How to install outdoor bamboo floor -- advantages of bamboo floor

Compared with the wood floor, the design of bamboo floor is much simpler. Some of them, like the traditional wood floor, are made into long strips with longitudinal lines, some of them are made into square lattice floors with various twill patterns. In addition, the effect of bamboo grain on the surface is different with different structures. You can choose the front cross section of bamboo. The bending strength, hardness tensile strength of bamboo are more than twice that of wood, the tensile bending strength of bamboo floor is more than 1.5 times higher than that of wood floor. After nearly 20 processes, bamboo floor also has various properties of wood floor, such as moderate elasticity, noise reduction, easy cleaning, etc.

Service life of outdoor bamboo floor

According to the product quality, if the good bamboo floor has enough corrosion resistance strength, it will be OK to use it for more than ten years. However, if it is a mixed brand, the cooking, health preservation pressing process are in place, it will be broken in less than three five years.

How to install the outdoor bamboo floor

1. First, before installing the outdoor bamboo floor, check whether the door can be opened freely. If , the lower side of the door shall be planed to a certain thickness, then a layer of PVC bottom film shall be paved above the ground, so as to achieve the effect of sound insulation moisture-proof. Then place the composite plate at the corner of the wall, mortise to the wall, leave about 10 mm expansion joint with wooden wedge.

2. When installing against the wall to the last plate, take a whole plate place it in parallel with the previous tenon. Leave a line of 10 mm at the end of the wall then saw it off. Install it until the end of the line. If the remaining material is 40 cm long, it can be reserved for the next line.

3. the second line, the special glue for the floor shall be evenly applied inside the mortise (the previous line shall be applied with glue). After the floor is completely installed, use a wet cloth plastic scraper to scrape off the overflowing glue in time, then use a hammer a wooden last to gently tap the floor.

4. After the first two lines are installed, use a rope ruler to calibrate in time to prevent unevenness. When the last line is left, take a whole board, put it on the installed floor, align it up down, take another floor, put it on this board, one end is against the wall, make a line, saw it off along the line (Note: don't forget to leave a 10 mm expansion joint), which is the floor of the required width.

5. Install the last row board, place the last block, squeeze the floor with special fasteners, withdraw the last 2 hours after installation. During installation, if there is any protruding floor pipe, the hole shall be opened on the floor. The diameter of the hole shall be at least 10 mm larger than the pipe diameter, the sawing surface shall also be at a 45 degree angle with the board surface.